Assembling the SCSI RIDER is easy, but there are some instructions for beginners.
Look at the finished product you should aim for first. Only 5 parts to solder to the PCB
Only the LED has polarity, so please be careful as shown in the figure.
F1 Polyswitch 1A and R1 330 ohms resistor have no polarity
Bend the pins of the SCSI connector slightly inward with tweezers.
Make sure the PCB is straight.
Both 50-pin female connectors have connector protrusions on the side of the SCSI RIDER logo on the PCB.
It's easy, but please be careful not to make any mistakes, Have Fun!