ジュニパーネットワークス技術認定資格プログラム(JNTCP)で、ジュニパーネットワークスのネットワーク/セキュリティ製品の設定.トラブルシューティングに関する能力を認定します。だからJN0-522 の試験を受けたい人がたくさんいます、でもまだいい学習資料が見つからないことに困っている人も少なくないと思います、今KILLTESTはJN0-522の更新版をリリースしました、このJN0-522問題集 精度が高くて、本当に信用できるよ。何よりこの問題集は合格することを保証して、万が一不合格になる場合全額返済します。詳しいことはhttp://www.killtest.jp/ を見てください
JN0-522の部分問題集、皆さん、参考のため、ご覧ください
10.Which statement is correct about tunnel interfaces?
A.They can have overlapping IP addresses.
B.They need to be configured in the zone where the protected resources reside.
C.They can be unnumbered and used in policy-based translations if the interface is in route mode.
D.They can be unnumbered from any interface residing on the same virtual router as the protected
resources.
Answer:D
11.You want to minimize the number of IP addresses, subnets, and policies in use. How should you
configure your tunnel interface?
A.Configure the tunnel interface with an IP address with a 32 bit subnet mask.
B.Configure the tunnel interface with an IP address with a 30 bit subnet mask.
C.Configure the tunnel interface as unnumbered and place the interface in the same zone as the
designated interface.
D.Configure the tunnel interface as unnumbered, but place the tunnel interface in a different zone than the
designated interface.
Answer:C
12.What is the purpose of the "Permitted IP" address on a ScreenOS device?
A.It defines a list of addresses that are trusted to perform management on the ScreenOS device.
B.It is used in policy rules to determine which user traffic is allowed through the ScreenOS device.
C.It defines which range of addresses that can access devices connected to the ScreenOS device.
D.It is the address that an external device uses to gain management access to a ScreenOS device.
Answer:A
14.Which ScreenOS CLI command is required to enable a policy during specified times, days, or dates?
A.set time
B.set clock
C.set calendar
D.set scheduler
Answer:D
15.Which ScreenOS CLI command would be useful for troubleshooting a policy deny?
A.get flow debug
B.debug flow basic
C.exec flow analysis
D.debug session basic
Answer:B
16.Assuming factory default settings, which statement describes the minimum requirements for WebUI
management access to the SSG 5?
A.Connect a PC addressed on the 192.168.1.0 subnet to any interface, open a browser and access
192.168.1.1.
B.Terminate the bootup sequence from the console device, open a browser on the console device and
access 192.168.1.1.
C.Connect a PC addressed on the 192.168.1.0 subnet, to the highest numbered interface and open a
browser and access 192.168.1.1.
D.Using the CLI, define an IP address on a physical interface, connect a PC to the interface and open a
browser to the interface address.
Answer:C
19.Which command can you use to view the log of IKE negotiations and results?
A.get event type 536
B.get ike cookie
C.get sa active
D.debug ike basic
Answer:A
20.What is the purpose of the VLAN1 interface?
A.It provides policy-based NAT for 802.1Q VLANs.
B.It provides an interface that can be used with 802.1Q VLANs in transparent mode.
C.It provides the ScreenOS device with a routable IP address while operating in route mode.
D.It provides an interface that can be used to remotely manage the ScreenOS device while operating in
transparent mode.
Answer:D
http://www.killtest.jp/JNCIA/
70-652 認定制度は、国際的に通用する高度な技術力の証として、専門知識と経験の深さを全世界共通の基準で測り認定する資格制度です。、70-652試験はMicrosoft 会社に主催されて、高い権威が持っています。貴方がもし70-652試験を通したら、もう先進的な技術を修得したことを表明します。だから最近70-652試験を受ける人もますます多くなって、それに応じていい学習資料もだんだん必要となっています。KILLTESTの70-652問題集が申し分のない学習資料と思います、この問題集を使って合格することを保証します、万が一不合格になる場合全額返済します。
70-652の問題集皆と分かち合います
1. You evaluate the purchase of a new server for the network.
A hardware supplier recommends a server that has the following hardware configuration:
¡¤Dua-core 32-bit processor
¡¤4 GB of RA
¡¤One singl-port network card
¡¤Two SATA hard disk
You need to change the hardware configuration to ensure that you can install the Hyper-V server role.
Which hardware component should you replace?
A. hard disks
B. memory
C. network card
D. processor
Answer: D
2. You install the Hyper-V server role on a Windows Server 2008 server.
You restart the server and discover that the Hyper-V Virtual Machine Management service has failed to
start. You restart the server again and enable the required BIOS settings for Hyper-V.
After a third restart, the Hyper-V Virtual Machine Management service still fails to start.
You need to ensure that the Hyper-V Virtual Machine Management service starts on the server.
What should you do?
A. Shut down the server, turn off the power, and then turn on the server.
B. Run the ocsetup Microsoft-Hyper-V command and restart the server.
C. Run the oclist | findstr /i Microsoft-Hyper-V command and restart the server.
D. Open the Services console and modify the Log on as settings for the Hyper-V Virtual Machine
Management service. Start the service.
Answer: A
4. You have a server that runs Windows Server 2008. The server is a member of a workgroup and has the
following components installed:
¡¤Microsoft SQL Server 2005 Express Edition Service Pack (SP2
¡¤Web Server (IIS) server rol
¡¤IIS 6 Metabase Compatibility role servic
¡¤IIS 6 WMI Compatibility role servic
You attempt to install Microsoft System Center Virtual Machine Manager (SCVMM) 2008 on the server.
The installation fails.
You need to ensure that you can install SCVMM on the server.
What should you do?
A. Disable User Account Control (UAC) on the server.
B. Remove the IIS 6 Metabase Compatibility role service.
C. Replace SQL Server 2005 Express Edition with a different edition.
D. Join the Windows Server 2008 server to an Active Directory domain.
Answer: D
5. You need to enable the Hyper-V server role on a Server Core installation of Windows Server 2008.
Which command should you run?
A. cscript scregedit.wsf /AR 0
B. start /w ocsetup Microsoft-Hyper-V
C. start /w servermanagercmd install Microsoft-Hyper-V
D. winrm quickconfig
Answer: B
http://www.killtest.jp/Microsoft/

IBM 技術者認定制度は、複数の製品分野の認定資格を取得することによって、より高度な専門技術者としての証となります。それに応じてIBM試験の難度もますます高くなって、例えば000-331 、000-794,000-974、000-428,000-415のような人気科目、最近困っている人が大勢いるね、KILLTESTの問題集は000-331、000-794、000-974 、000-428,000-415といったIBM認定資格を取得するための近道となります。それから000-331、000-794、000-974、000-428,000-415 中での000-331問題集皆と分かち合います

1. Which of the following properly describes the 4-port Ethernet PCI adapter card used in IBM Power
Systems servers?
A. A single physical connection with four virtual MAC addresses
B. The four Ethernet connections on the card share a common PCI bus.
C. A single connection provides the virtual bandwidth of four Ethernet cards
D. Four separate LPARs can each use a port on the 4-port Ethernet PCI adapter card.
Answer: B
2. A customer with several older pSeries servers plans to consolidate to a single Power Systems server.
Which of the following tools can provide output that can be merged with Work Load Estimator to size the
upgrade based on utilization and growth trends?
A. Insight Manager
B. System Planning Tool
C. Tivoli Capacity Planner
D. Electronic Service Agent
Answer: B
3. A distribution company is running Oracle 9i and Solaris 8 on a Sun E10K. The prospect wants to
upgrade their technology and lower their TCO. Which of the following is the first thing the sales
representative should do to move them to a POWER6 solution?
A. Conduct an Oracle SAR.
B. Offer a proof of concept system
C. Engage the IBM Migration Factory team.
D. Determine if funding and skills are available.
Answer: D
4. A Power Systems sales representative has a meeting with the CIO of a telecommunications company.
They have twenty POWER4 systems now. They have ample budget for the new POWER6 systems. They
want to move very quickly into virtualization and are anxious to order additional servers. The customer
must be in production within 90 days. Which of the following is the key challenge for this opportunity?
A. Adequate funding
B. Business problem
C. Project management
D. Software requirements
Answer: C
5. A Power Systems sales representative has a meeting with the I/S Director of a large company with
twenty HP Superdomes systems. They plan to move their applications to IBM POWER6 servers and have
ample budget. Which of the following is key for the sales representative to identify?
A. Space requirements
B. Software requirements
C. POWER6 energy requirements
D. Project timing requirements
Answer: B
6. A Power Systems sales representative has had several meetings with the CIO of a large company.
They have a mixture of SUN and IBM servers now. The CEO has a long term relationship with the SUN
representative. They have ample budget to refresh all the systems. Which of the following is key for the
sales representative to identify?
A. Business problem
B. Software requirements
C. Decision-maker and process
D. Project timing requirements
Answer: C
7. A customer requires the maximum memory per processor on a Power Blade that supports partition
mobility. Which Blade server meets these requirements?
A. JS12
B. JS20
C. JS21
D. JS22
Answer: A
8. A customer plans to consolidate several web applications whose workloads change frequently. Upper
management is very concerned about data security between applications but is very cost conscious.
Which of the following will best meet their requirements?
A. IVM
B. VIOS
C. DLPAR
D. Partition Mobility
Answer: C
9. A customer is concerned that if several systems are consolidated on a single Power Systems server,
the administration costs will not go down. Which virtualization feature should be discussed to minimize
this concern?
A. Virtual LAN (VLAN)
B. Virtual I/O Server (VIOS)
C. Dynamic Logical Partition (DLPAR)
D. Simultaneous Multi-threading (SMT)
Answer: C
10. A POWER6 server customer plans to implement 2 micro partitions (one Linux, one AIX) to be
managed by an existing HMC on a 520 server. Which of the following is the minimum version of PowerVM
Editions to meet this need?
A. Entry
B. Express
C. Standard
D. Enterprise
Answer: C