1. Prepare a pair of suitable slippers at the bottom, then use the cardboard to copy the sole accurately, and cut 2 pieces according to the pattern. In addition, you need to cut a large piece of clean cotton or thin sponge, and one piece is 1.5cm small. Put a hard cloth on the ring or use a cloth to lining the base fabric. The second step of the cotton slippers is to stack the upper, the cotton, the hard lining and the bottom fabric in turn, and then fix the circumference on the side, and sew some cotton to the middle while sewing. Making cotton slippers(cotton slippers manufacturer) is a bit more complicated, not as casual as a graffiti beach flip flop.
2, The following to do the upper, cut the old slippers face flat, and then copy to the paper, but pay attention to the side of the stitching to release 1CM. Put the upper, cotton, hard lining and lining in order, and fix it around. The trick of cotton slippers is to superimpose the lining over the face, otherwise, the lining will be uneven. It is necessary to wrinkle the section of the round head of the shoe and make the toe cap arch in a circular arc shape, but it is better not to have obvious pleats.
3, The finished shoe surface is stitched to the finished sole. The key point of this step of cotton slippers is to do the three matching stitching points (the center point of the toe cap to the center point of the sole; the upper The left endpoint is aligned with the left starting point of the sole; the right end of the upper is aligned with the right end of the sole). Then, the sole and the upper are stitched together one by one, and the first stitch is stitched on the front of the shoe; the second stitch is preferably stitched by hand, and the rolled strip is tightly fixed on the opposite side of the sole.
4,
A. Fix the rolled shoes to the ready-made foam soles. First, place the bottom of the slippers on the bubble bottom and evenly select 3 to 4 pairs of stitched points. Fixed suture
B. Then stitch one stitch in turn; the stitching method uses a back stitch, but the stitch length can be larger, which is faster;
C. The position of the stitching is on the edge of the edge of the piping or directly on the piping. However, the stitching is even and good. The line should be chosen to be unobtrusive. It is a very thick polyester thread or nylon thread.
D. This step requires great effort. The tool should be full. The needle should be larger, but it is not the largest one in the box. The middle finger should have a hard thimble. The index finger should have a plastic finger cot so that the sewing is much easier.
E. There is also a foam sole that is best to buy that kind of softer, preferably with a groove at the bottom, so that the stitch is directly sewn into the groove, which is easier to grasp.
This is the process of making cotton slippers. Of course, if you don't want to do it yourself, you can go to our website(Thinge sandals manufacturers) to buy it.