君が後悔しないようにもっと少ないお金を使って大きな良い成果を取得するためにPass4Testを選択してください。Pass4Testはまた一年間に無料なサービスを更新いたします。


ここで無料にPass4Testが提供したCiscoの642-618試験の部分練習問題と解答をダウンロードできて、一度Pass4Testを選ばれば、弊社は全力に貴方達の合格を頑張ります。貴方達の試験に合格させることができないと、すぐに全額で返金いたします。


当面の実際のテストを一致させるために、Pass4TestのCiscoの642-618問題集の技術者はずべての変化によって常に問題と解答をアップデートしています。それに我々はいつもユーザーからのフィードバックを受け付け、アドバイスの一部をフルに活用していますから、完璧なPass4TestのCiscoの642-618問題集を取得しました。Pass4Testはそれを通じていつまでも最高の品質を持っています。


IT業種は急激に発展しているこの時代で、IT専門家を称賛しなければならないです。彼らは自身が持っている先端技術で色々な便利を作ってくれます。それに、会社に大量な人的·物的資源を節約させると同時に、案外のうまい効果を取得しました。彼らの給料は言うまでもなく高いです。そのような人になりたいのですか。羨ましいですか。心配することはないです。Pass4TestのCiscoの642-618トレーニング資料はあなたに期待するものを与えますから。Pass4Testを選ぶのは、成功を選ぶということになります。


試験番号:642-618問題集

試験科目:Cisco 「Deploying Cisco ASA Firewall Solutions (FIREWALL v2.0) 」

一年間無料で問題集をアップデートするサービスを提供いたします

最近更新時間:2013-09-02

問題と解答:全137問

あなたはインターネットでCiscoの642-618認証試験の練習問題と解答の試用版を無料でダウンロードしてください。そうしたらあなたはPass4Testが用意した問題集にもっと自信があります。早くPass4Testの問題集を君の手に入れましょう。


なぜ受験生はほとんどPass4Testを選んだのですか。Pass4Testは実践の検査に合格したもので、Pass4Testの広がりがみんなに大きな利便性と適用性をもたらしたからです。Pass4Testが提供したCiscoの642-618試験資料はみんなに知られているものですから、試験に受かる自信がないあなたはPass4TestのCiscoの642-618試験トレーニング資料を利用しなければならないですよ。Pass4Testを利用したら、あなたはぜひ自信に満ちているようになり、これこそは試験の準備をするということを感じます。


購入前にお試し,私たちの試験の質問と回答のいずれかの無料サンプルをダウンロード:http://www.pass4test.jp/642-618.html


NO.1 When will a Cisco ASA that is operating in transparent firewall mode perform a routing table lookup
instead of a MAC address table lookup to determine the outgoing interface of a packet?
A. if multiple context mode is configured
B. if the destination MAC address is unknown
C. if the destination is more than a hop away from the Cisco ASA
D. if NAT is configured
E. if dynamic ARP inspection is configured
Answer: D

Cisco問題集   642-618認定証   642-618

NO.2 On the Cisco ASA, tcp-map can be applied to a traffic class using which MPF CLI configuration
command?
A. inspect
B. sysopt connection
C. tcp-options
D. parameters
E. set connection advanced-options
Answer: E

Cisco   642-618   642-618参考書   642-618

NO.3 Refer to the exhibit.
Which statement about the MPF configuration is true?
A. Any non-RFC complaint FTP traffic will go through additional deep FTP packet inspections.
B. FTP traffic must conform to the FTP RFC, and the FTP connection will be dropped if the PUT command
is used.
C. Deep FTP packet inspections will be performed on all TCP inbound and outbound traffic on the outside
interface.
D. The ftp-pm policy-map type should be type inspect.
E. Due to a configuration error, all FTP connections through the outside interface will not be permitted.
Answer: B

Cisco   642-618   642-618問題集

NO.4 When enabling a Cisco ASA to send syslog messages to a syslog server, which syslog level will
produce the most messages?
A. notifications
B. informational
C. alerts
D. emergencies
E. errors
F. debugging
Answer: F

Cisco   642-618認定資格   642-618   642-618

NO.5 Refer to the exhibit.
Which statement about the policy map named test is true?
A. Only HTTP inspection will be applied to the TCP port 21 traffic.
B. Only FTP inspection will be applied to the TCP port 21 traffic.
C. both HTTP and FTP inspections will be applied to the TCP port 21 traffic.
D. No inspection will be applied to the TCP port 21 traffic, because the http class map configuration
conflicts with the ftp class map.
E. All FTP traffic will be denied, because the FTP traffic will fail the HTTP inspection.
Answer: B

Cisco認証試験   642-618参考書   642-618

NO.6 Which flag shown in the output of the show conn command is used to indicate that an initial SYN
packet is from the outside (lower security-level interface)?
A. B
B. D
C. b
D. A
E. a
F. i
G. I
H. O
Answer: A

Cisco   642-618認証試験   642-618   642-618認定資格

NO.7 In one custom dynamic application, the inside client connects to an outside server using TCP port
4444 and negotiates return client traffic in the port range of 5000 to 5500. The server then starts
streaming UDP data to the client on the negotiated port in the specified range. Which Cisco ASA feature
or command supports this custom dynamic application?
A. TCP normalizer
B. TCP intercept
C. ip verify command
D. established command
E. tcp-map and tcp-options commands
F. set connection advanced-options command
Answer: D

Cisco   642-618   642-618

NO.8 Which Cisco ASA feature enables the ASA to do these two things? 1) Act as a proxy for the server and
generate a SYN-ACK response to the client SYN request. 2) When the Cisco ASA receives an ACK back
from the client, the Cisco ASA authenticates the client and allows the connection to the server.
A. TCP normalizer
B. TCP state bypass
C. TCP intercept
D. basic threat detection
E. advanced threat detection
F. botnet traffic filter
Answer: C

Cisco参考書   642-618認定資格   642-618

NO.9 What mechanism is used on the Cisco ASA to map IP addresses to domain names that are contained in
the botnet traffic filter dynamic database or local blacklist?
A. HTTP inspection
B. DNS inspection and snooping
C. WebACL
D. dynamic botnet database fetches (updates)
E. static blacklist
F. static whitelist
Answer: B

Cisco参考書   642-618認定証   642-618練習問題

NO.10 In which type of environment is the Cisco ASA MPF set connection advanced-options tcp-statebypass
option the most useful?
A. SIP proxy
B. WCCP
C. BGP peering through the Cisco ASA
D. asymmetric traffic flow
E. transparent firewall
Answer: D

Cisco認証試験   642-618   642-618   642-618   642-618認定資格

NO.11 By default, how does the Cisco ASA authenticate itself to the Cisco ASDM users?
A. The administrator validates the Cisco ASA by examining the factory built-in identity certificate
thumbprint of the Cisco ASA.
B. The Cisco ASA automatically creates and uses a persistent self-signed X.509 certificate to authenticate
itself to the administrator.
C. The Cisco ASA automatically creates a self-signed X.509 certificate on each reboot to authenticate
itself to the administrator.
D. The Cisco ASA and the administrator use a mutual password to authenticate each other.
E. The Cisco ASA authenticates itself to the administrator using a one-time password.
Answer: C

Cisco過去問   642-618練習問題   642-618参考書

NO.12 Which Cisco ASA feature is implemented by the ip verify reverse-path interface interface_name
command?
A. uRPF
B. TCP intercept
C. botnet traffic filter
D. scanning threat detection
E. IPS (IP audit)
Answer: A

Cisco   642-618   642-618

NO.13 Refer to the exhibit.
What can be determined about the connection status?
A. The output is showing normal activity to the inside 10.1.1.50 web server.
B. Many HTTP connections to the 10.1.1.50 web server have successfully completed the three-way TCP
handshake.
C. Many embryonic connections are made from random sources to the 10.1.1.50 web server.
D. The 10.1.1.50 host is triggering SYN flood attacks against random hosts on the outside.
E. The 10.1.1.50 web server is terminating all the incoming HTTP connections.
Answer: C

Cisco認証試験   642-618認証試験   642-618   642-618

NO.14 Refer to the exhibit.
Which Cisco ASA feature can be configured using this Cisco ASDM screen?
A. Cisco ASA command authorization using TACACS+
B. AAA accounting to track serial, ssh, and telnet connections to the Cisco ASA
C. Exec Shell access authorization using AAA
D. cut-thru proxy
E. AAA authentication policy for Cisco ASDM access
Answer: D

Cisco   642-618   642-618   642-618練習問題

NO.15 By default, which traffic can pass through a Cisco ASA that is operating in transparent mode without
explicitly allowing it using an ACL.?
A. ARP
B. BPDU
C. CDP
D. OSPF multicasts
E. DHCP
Answer: A

Cisco認定試験   642-618問題集   642-618問題集   642-618認証試験   642-618

NO.16 Which statement about the default ACL logging behavior of the Cisco ASA is true?
A. The Cisco ASA generates system message 106023 for each denied packet when a deny ACE is
configured.
B. The Cisco ASA generates system message 106023 for each packet that matched an ACE.
C. The Cisco ASA generates system message 106100 only for the first packet that matched an ACE.
D. The Cisco ASA generates system message 106100 for each packet that matched an ACE.
E. No ACL logging is enabled by default.
Answer: A

Cisco   642-618   642-618練習問題   642-618過去問

NO.17 Refer to the exhibit.
What does the * next to the CTX security context indicate?
A. The CTX context is the active context on the Cisco ASA.
B. The CTX context is the standby context on the Cisco ASA.
C. The CTX context contains the system configurations.
D. The CTX context has the admin role.
Answer: D

Cisco参考書   642-618練習問題   642-618過去問   642-618   642-618過去問

NO.18 Which option is not supported when the Cisco ASA is operating in transparent mode and also is using
multiple security contexts?
A. NAT
B. shared interface
C. security context resource management
D. Layer 7 inspections
E. failover
Answer: B

Cisco認定資格   642-618   642-618過去問   642-618過去問

NO.19 Refer to the exhibit.
What is a reasonable conclusion?
A. The maximum number of TCP connections that the 10.1.1.99 host can establish will be 146608.
B. All the connections from the 10.1.1.99 have completed the TCP three-way handshake.
C. The 10.1.1.99 hosts are generating a vast number of outgoing connections, probably due to a virus.
D. The 10.1.1.99 host on the inside is under a SYN flood attack.
E. The 10.1.1.99 host operations on the inside look normal.
Answer: C

Cisco認定試験   642-618   642-618過去問   642-618

NO.20 Refer to the exhibit.
Which command enables the stateful failover option?
A. failover link MYFAILOVER GigabitEthernet0/2
B. failover lan interface MYFAILOVER GigabitEthernet0/2
C. failover interface ip MYFAILOVER 172.16.5.1 255.255.255.0 standby 172.16.5.10
D. preempt
E. failover group 1 primary
F. failover lan unit primary
Answer: A

Cisco   642-618   642-618   642-618認定資格

Pass4Testは最新の70-467試験問題集と高品質のVCP-510認定試験の問題と回答を提供します。Pass4Testの70-465 VCEテストエンジンとHP2-E56試験ガイドはあなたが一回で試験に合格するのを助けることができます。高品質の70-487トレーニング教材は、あなたがより迅速かつ簡単に試験に合格することを100%保証します。試験に合格して認証資格を取るのはそのような簡単なことです。


記事のリンク:http://www.pass4test.jp/642-618.html