もしあなたはまだCiscoの642-691試験に合格するのために悩まればPass4Testは今あなたを助けることができます。Pass4Testは高品質の学習資料をあなたを助けて優秀なCiscoの642-691会員の認証を得て、もしあなたはCisco 642-691の認証試験を通して自分を高めるの選択を下ろして、Pass4Testはとてもよい選択だと思います。
Pass4Testはあなたの１００パーセントの合格率を保証します。例外がないです。いまPass4Testを選んで、あなたが始めたいトレーニングを選んで、しかも次のテストに受かったら、最も良いソース及び市場適合性と信頼性を得ることができます。Pass4TestのCiscoの642-691問題集と解答は642-691認定試験に一番向いているソフトです。
Pass4TestのCiscoの642-691試験のトレーニングキットはPass4TestのIT技術専門家たちによって開発されたのです。そのデザインは当面の急速に変化するIT市場と密接な関係があります。Pass4Testのトレーニングはあなたを助けて継続的に発展している技術を利用して、問題を解決する能力を高めると同時に仕事についての満足度を向上させることができます。Pass4TestのCiscoの642-691の認証したカバー率は１００パーセントに達したのですから、弊社の問題と解答を利用する限り、あなたがきっと気楽に試験に合格することを保証します。
試験番号：642-691問題集
試験科目：Cisco 「CCIP BGP + MPLS Exam (BGP + MPLS)」
Pass4Testのシニア専門家チームはCiscoの642-691試験に対してトレーニング教材を研究できました。Pass4Testが提供した教材を勉強ツルとしてCiscoの642-691認定試験に合格するのはとても簡単です。Pass4Testも君の１００％合格率を保証いたします。
Pass4TestのIT業界専門家チームは彼らの経験と知識を利用して絶えないな試験対策材料の品質を高めて、受験者の需要を満たして、受験者のはじめてCisco 642-691試験を順調に合格するを保証します。あなた達はPass4Testの商品を購入してもっともはやく正確に試験に関する情報を手に入れます。Pass4Testの商品は試験問題を広くカーバして、認証試験の受験生が便利を提供し、しかも正確率100%です。そして、試験を安心に参加してください。
購入前にお試し,私たちの試験の質問と回答のいずれかの無料サンプルをダウンロード：http://pdf.pass4test.jp/642-691.pdf
NO.1 For which purpose is the command mpls ldp maxhops used?
A. In large ATM-MPLS networks, the LFIB can become too large and it may be necessary to limit the
maximum diameter of the MPLS LSPs.
B. Because downstream-on-demand label allocation uses hop count to control loop detection, it maybe
necessary to limit the maximum diameter of the MPLS network.
C. Because end-to-end delay can cause problems with some voice applications, it may be necessary to
limit the maximum diameter of the MPLS network.
D. When interconnecting large frame mode MPLS and cell mode networks it may be necessary to limit the
maximum network diameter to prevent forwarding loops.
Answer: B
Cisco 642-691 642-691
NO.2 Based on the topology diagram shown in the exhibit, when should BGP be used as the routing protocol
between the customer and the ISP?
A. If physical link failures can not be detected by the link-level procedures.
B. If the customer wants to affect how the ISP will route the customer's traffic out to the rest of the Internet.
C. If the ISP does not support static routing with the customer.
D. If the customer is using provider-assigned (PA) addresses inside the customer's network.
E. If the customer is using private addresses inside the customer's network.
Answer: A
Cisco 642-691 642-691
NO.3 What does the following command accomplish?
sanjose#clear ip bgp 10.1.1.1 in prefix-filter
A. The sanjose router will perform an outbound soft reconfig to the 10.1.1.1 neighbor.
B. The sanjose router will send out the ORF prefix-list so that a new route refresh will be received from the
1.1.1 neighbor.
C. The 10.1.1.1 router will perform an inbound soft reconfig on the updates from the sanjose neighbor.
D. The 10.1.1.1 router will send out the ORF prefix-list so that a new route refresh will be received from
the sanjose neighbor.
E. The bgp session between the sanjose and the 10.1.1.1 router will be reset so that all the new bgp
updates from the 10.1.1.1 router can be processed by the inbound prefix-list at the sanjose router.
F. The bgp session between the sanjose and the 10.1.1.1 router will be reset so that all the new bgp
updates from the sanjose router can be processed by the inbound prefix-list at the 10.1.1.1 router.
Answer: B
Cisco認定試験 642-691認証試験 642-691練習問題 642-691 642-691問題集
NO.4 Refer to the diagram.
What problem can be caused by the second P router summarizing the loopback address of the egress PE
router.?
A. The first P router will be faced with a VPN label which it does not understand.
B. The second P router will be faced with a VPN label which it does not understand.
C. The egress PE router will not be able to establish a label switch path (LSP) to the ingress PE router.
D. A label switch path (LSP) will be established from the ingress PE router to the egress PE router, an
event that is not desirable.
E. The ingress PE router will not be able to receive the VPN label from the egress PE router via MP-IBGP.
Answer: B
Cisco過去問 642-691 642-691参考書 642-691
NO.5 Refer to the exhibit.
\Which two of the following statements about the MPLS configurations are true? (Choose two.)
A. The VPI range being configured is the default VPI range.
B. The router is missing the mpls label protocol ldp configuration command on its ATM 0/0.1 subinterface
to make it an LC-ATM enabled subinterface.
C. There is a problem with the configurations because the control VC should be set to 0 32 instead.
D. The ATM switch is using VC merge since VC merge is enabled by default.
E. For MPLS label allocations, both VPI 6 and 7 can be used.
Answer: DE
Cisco 642-691 642-691認証試験 642-691練習問題
NO.6 Which two of the following statements regarding LDP are true? (Choose two.)
A. LDP can also be used between nonadjacent routers using multicast LDP hello messages.
B. LDP does not require periodic hello messages once the LDP session has been established between
the LDP peers.
C. LDP hello messages use TCP packets with a destination port number of 646.
D. Multiple sessions can be established between a pair of LSRs if they use multiple label spaces.
E. Per-platform label space can be identified by a label space ID of 0 in the LDP identifier field.
Answer: DE
Cisco 642-691 642-691 642-691過去問 642-691認定証 642-691認定資格
NO.7 On a dedicated subinterface implementation, PE-2 must establish an address-family vrf IPv4 BGP
neighbor relationship with which router?
A. CE-1
B. CE-2
C. PE-1
D. PE-IG
E. CE-1 and CE-2
F. PE-1 and PE-IG
Answer: B
Cisco問題集 642-691問題集 642-691 642-691 642-691
NO.8 What are three drawbacks of a peer-to-peer VPN using a shared provider edge (PE) router? (Choose
three.)
A. A full mesh of virtual circuits is required between the customer sites.
B. All the customers have to share a common IP address space.
C. Optimal routing between customer sites cannot be guaranteed.
D. The shared PE router has to know all routes for all customers.
E. Packet filters are required on the PE routers.
Answer: BDE
Cisco 642-691 642-691
NO.9 In a central services topology, which routes do client VRFs contain?
A. routes from the client site, but not from the server site
B. routes from the server site, but not from the client site
C. routes from both the client site and the server site
D. only EBGP routes from either the client site or the server site
Answer: C
Cisco練習問題 642-691過去問 642-691 642-691練習問題
NO.10 Based on the network diagram shown in the exhibit, what is the correct configuration on the customer
edge router used to conditionally announce the customer networks to the ISP?
A. router bgp 65001
! neighbor commands not shown
network 192.168.8.0 mask 255.255.252.0
!
ip route 192.168.8.0 255.255.252.0 192.168.8.33
B. router bgp 65001
! neighbor commands not shown
aggregate-address 192.168.8.0 255.255.252.0 summary-only
!
ip route 192.168.8.0 255.255.252.0 192.168.8.33
C. router bgp 65001
! neighbor commands not shown
network 192.168.8.0
network 192.168.9.0
network 192.168.10.0
network 192.168.11.0
!
ip route 192.168.8.0 255.255.255.0 null0
ip route 192.168.9.0 255.255.255.0 null0
ip route 192.168.10.0 255.255.255.0 null0
ip route 192.168.11.0 255.255.255.0 null0
D. router bgp 65001
! neighbor commands not shown
aggregate-address 192.168.8.0 255.255.252.0 summary-only
!
router ospf 1
network 192.168.8.0 0.0.3.255 area 0
E. router bgp 65001
! neighbor commands not shown
aggregate-address 192.168.8.0 255.255.252.0
!
ip route 192.168.8.0 255.255.252.0 null0
Answer: A
Cisco認定試験 642-691 642-691認定資格 642-691
今の多士済々な社会の中で、IT専門人士はとても人気がありますが、競争も大きいです。だからいろいろな方は試験を借って、自分の社会の地位を固めたいです。642-691認定試験はCiscoの中に重要な認証試験の一つですが、Pass4TestにIT業界のエリートのグループがあって、彼達は自分の経験と専門知識を使ってCisco 642-691認証試験に参加する方に対して問題集を研究続けています。