多くの人々は高い難度のIT認証試験に合格するのは専門の知識が必要だと思います。それは確かにそうですが、その知識を身につけることは難しくないとといわれています。IT業界ではさらに強くなるために強い専門知識が必要です。
Symantecの251-251認証試験の合格証は多くのIT者になる夢を持つ方がとりたいです。でも、その試験はITの専門知識と経験が必要なので、合格するために一般的にも大量の時間とエネルギーをかからなければならなくて、助簡単ではありません。Pass4Testは素早く君のSymantec試験に関する知識を補充できて、君の時間とエネルギーが節約させるウェブサイトでございます。Pass4Testのことに興味があったらネットで提供した部分資料をダウンロードしてください。
Symantec 251-251認証試験を通るために、いいツールが必要です。Symantec 251-251認証試験について研究の資料がもっとも大部分になって、Pass4Testは早くてSymantec 251-251認証試験の資料を集めることができます。弊社の専門家は経験が豊富で、研究した問題集がもっとも真題と近づいて現場試験のうろたえることを避けます。
試験番号：251-251問題集
試験科目：Symantec 「Administration of HA Solutions for UNIX (VCS 5.0)」
251-251はSymantecの一つ認証試験として、もしSymantec認証試験に合格してIT業界にとても人気があってので、ますます多くの人が251-251試験に申し込んで、251-251試験は簡単ではなくて、時間とエネルギーがかかって用意しなければなりません。
現在の社会の中で優秀な人材が揃てIT人材も多く、競争もとても大きくて、だから多くのIT者はにIT関する試験に参加するIT業界での地位のために奮闘しています。251-251試験はSymantecの一つ重要な認証試験で多くのIT専門スタッフが認証される重要な試験です。
購入前にお試し,私たちの試験の質問と回答のいずれかの無料サンプルをダウンロード：http://pdf.pass4test.jp/251-251.pdf
NO.1 During a test of a NIC resource the VCS engine log indicates that the service group and the IP resource
enter the FAULTED state on all systems in the cluster. The NIC resource enters the ONLINE state after
the root cause of the fault is corrected. Which default attribute setting allows the service group to attempt
to start without manual intervention?
A.AutoStart
B.AutoClear
C.AutoRestart
D.AutoFailover
Answer:C
Symantec 251-251過去問 251-251 251-251認証試験
NO.2 Which types of monitoring can be performed on Oracle resources? (Choose two.)
A.detail monitoring
B.basic level monitoring
C.kernel level monitoring
D.specific monitoring
E.service monitoring
Answer:A B
Symantec認定試験 251-251認定試験 251-251 251-251練習問題
NO.3 You are adding a system to a running cluster. You have successfully performed these steps on the
system that you are adding: 1. installed, configured, and tested all application resources required 2.
installed VCS 3. configured and started VCS communications (LLT and GAB) What is the next step that
you perform?
A.update the resource attributes to enable resources to run on the new system
B.update the service group attributes to enable groups to run on the new system
C.change the cluster attribute for VCS user names to match accounts on the new system
D.change the owner of the system attributes so that all cluster systems are the same
Answer:B
Symantec参考書 251-251 251-251参考書 251-251認定試験 251-251過去問
NO.4 Which procedure must be followed to remove the resource type TypeA from an active VCS cluster?
A.remove all resources of TypeA, remove TypeA, and remove TypeA packages
B.remove TypeA, then execute the hatype esync command
C.stop VCS, remove all resources of TypeA, and start VCS
D.execute the hatype -remove command which will remove all the resources
Answer:A
Symantec認定試験 251-251 251-251 251-251
NO.5 Which attributes impact service group failover? (Choose three.)
A.FailOver
B.AutoFailOver
C.Faulted
D.FaultPropagation
E.Frozen
Answer:B D E
Symantec参考書 251-251練習問題 251-251練習問題 251-251 251-251練習問題
NO.6 Which components are installed when you execute the installvcs script? (Choose two.)
A.bundled agents
B.database agents
C.cluster file system
D.GAB driver
E.cluster volume manager
Answer:A D
Symantec過去問 251-251問題集 251-251 251-251認定試験
NO.7 Under which condition can a service group be AutoDisabled?
A.when hashadow cannot restart HAD on a system
B.when the system is in a jeopardy membership
C.when a firm service group dependency exists between two service groups and the parent service group
fails
D.when a firm service group dependency exists between two service groups and the child service group
fails
Answer:A
Symantec 251-251 251-251 251-251 251-251
NO.8 Which conditions are recommended for a successful VCS patch installation? (Choose two.)
A.The clustered application must be shut down.
B.VCS must be shut down only on the server being patched.
C.VCS must be shut down on all cluster nodes.
D.GAB and LLT must be shut down on all cluster nodes.
E.GAB and LLT must remain running and connected.
Answer:C D
Symantec 251-251参考書 251-251 251-251認定試験
NO.9 Which resource type attributes can be set in order to tune VCS failover characteristics? (Choose two.)
A.Flags
B.RestartLimit
C.ToleranceLimit
D.OfflineTimeout
E.OfflineMonitorInterval
Answer:B C
Symantec認証試験 251-251 251-251 251-251
NO.10 When preparing to install VCS on the S1 and S2 systems, what should you do to verify software
compatibility? (Choose three.)
A.check the VCS release notes for supported software
B.run the installvcs recheck S1 S2 command
C.let the installvcs script check compatibility at install
D.run the installvcs ompat S1 S2 command
E.check the Symantec Enterprise Support website
Answer:A B E
Symantec 251-251認定試験 251-251認定資格 251-251 251-251
NO.11 Which feature of VCS can prevent overloading of a system's resources in the event of service group
failover?
A.Parallel Service Groups
B.Capacities
C.Limits
D.Load Failover Policy
Answer:C
Symantec認証試験 251-251 251-251 251-251 251-251認定証
NO.12 What is the default level of authorization of a new VCS user?
A.Cluster Administrator
B.Cluster Operator
C.Cluster Guest
D.Group Administrator
E.Group Operator
Answer:C
Symantec 251-251 251-251問題集 251-251
NO.13 Which attribute enables VCS to bring a resource online after it goes offline unexpectedly and before
faulting the resource?
A.RestartLimit
B.OnlineRestartLimit
C.AutoRestartLimit
D.OnlineRetryLimit
Answer:A
Symantec 251-251認定証 251-251認定試験 251-251 251-251
NO.14 You are installing a VCS upgrade that does not require a system reboot, but does require a VCS
restart. Which method maximizes user access to the clustered applications during the upgrade?
A.use the VCS rolling upgrade option which restarts VCS transparently
B.stop VCS using the orce option and then restart VCS on each system
C.evacuate service groups while upgrading one system at a time
D.stop VCS using the all option and then restart VCS on each system
Answer:B
Symantec 251-251 251-251 251-251 251-251認定証
NO.15 Which directive in the llttab file defines a network interface for a heartbeat?
A.nic
B.link
C.heartbeat
D.hbdev
Answer:B
Symantec 251-251 251-251 251-251認定証 251-251
NO.16 Which statement is true about the violation trigger?
A.A violation trigger must be written as a shell script.
B.A violation trigger and notification are mutually exclusive.
C.A violation trigger is dependent on notification to work.
D.A violation trigger is automatically executed when events occur.
Answer:D
Symantec 251-251 251-251 251-251 251-251過去問
NO.17 Which VCS resource attribute setting prevents VCS from interpreting a Monitor entry point timeout as a
resource fault?
A.MonitorFault=0
B.MonitorFaultTimeout=240
C.FaultMonitor=240
D.FaultOnMonitor=4
Answer:D
Symantec 251-251 251-251練習問題
NO.18 VCS is to be installed in a secure environment where remote installation between systems is
impossible. The VCS configuration parameters were captured in a file using the installation script on the
first system. What can be used to read the contents of the configuration file when executing locally on the
remaining systems?
A.-autoconfig
B.-configfile
C.-vcsconfig
D.-responsefile
Answer:D
Symantec認定資格 251-251認定証 251-251練習問題 251-251問題集 251-251参考書 251-251問題集
NO.19 Which resource type attributes can be set in order to tune VCS failover characteristics? (Choose two.)
A.AutoStart
B.ConfInterval
C.ConfTimeout
D.MonitorInterval
E.OfflineMonitorInterval
Answer:B D
Symantec認定試験 251-251 251-251 251-251認定証
NO.20 Which text files are created at the end of a successful run of installvcs -installonly? (Choose three.)
A.log
B.response
C.gabtab
D.llttab
E.summary
Answer:A B E
Symantec 251-251練習問題 251-251練習問題 251-251 251-251 251-251参考書