Ciscoの642-457の認証試験は現在IT業界でもっとも人気があって、その試験に合格すれば君の生活と仕事にいいです。 Pass4TestはCiscoの642-457の認証試験の合格率を高めるのウエブサイトで、Pass4Test中のIT業界の専門家が研究を通じてCiscoの642-457の認証試験について問題集を研究し続けています。100%合格率は彼らの研究成果でございます。Pass4Testを選られば、成功しましょう。
ここで無料にPass4Testが提供したCiscoの642-457試験の部分練習問題と解答をダウンロードできて、一度Pass4Testを選ばれば、弊社は全力に貴方達の合格を頑張ります。貴方達の試験に合格させることができないと、すぐに全額で返金いたします。
Pass4Testは Ciscoの642-457認定試験の認証に対して特別な教育ツールで、あなたに多くの時間とお金が使わないようにIT技術にも身につけさせるサイトでございます。Pass4Testは専門家チームが自分の知識と経験をを利用してCiscoの642-457認証試験の問題集を研究したものでございます。
試験番号：642-457問題集
試験科目：Cisco 「Implementing Cisco Unified Communications Manager, Part 2 v8.0 (CIPT2 v8.0)」
今は時間がそんなに重要な社会でもっとも少ないお時間を使って試験に合格するのは一番よいだと思います。Pass4Testが短期な訓練を提供し、一回に君の試験に合格させることができます。
Cisco 642-457認証はIT業界にとても重要な地位があることがみんなが、たやすくその証本をとることはではありません。いまの市場にとてもよい問題集が探すことは難しいです。でも、Pass4Testにいつでも最新な問題を探すことができ、完璧な解説を楽に勉強することができます。
購入前にお試し,私たちの試験の質問と回答のいずれかの無料サンプルをダウンロード：http://pdf.pass4test.jp/642-457.pdf
NO.1 Refer to the exhibit.
Which configuration elements must match for adjacent neighbors to establish a SAF neighbor
relationship?
A. the label name specified in the router eigrp command
B. the autonomous-system number specified in the service-family ipv4 autonomous-system command
C. the sf-interface configuration
D. the topology base configurations
E. the label name specified in the router eigrp command and the autonomous-system number
Answer: B
Cisco過去問 642-457 642-457参考書
NO.2 Which statement best describes globalized call routing in Cisco Unified Communications Manager?
A.All incoming calling numbers on the phones are displayed as an E.164 with the + prefix.
B.Call routing is based on numbers represented as an E.164 with the + prefix format.
C.All called numbers sent out to the PSTN are in E.164 with the + prefix format.
D.The CSS of all phones contain partitions assigned to route patterns that are in global format.
E.All phone directory numbers are configured as an E.164 with the + prefix.
Answer: B
Cisco 642-457参考書 642-457参考書 642-457 642-457参考書 642-457
NO.3 Refer to the exhibit.
Which trunks would be most suitable for Connection Y?
A.an H.225 trunk (gatekeeper-controlled)
B.intercluster trunk (gatekeeper-controlled)
C.a SIP trunk on the U.S. cluster and an intercluster trunk on the remote cluster
D.intercluster trunk (nongatekeeper-controlled)
E.No extra connections are required. As long as IP connectivity exists, you need only configure a route
pattern for each site. The Cisco Unified Communications Manager will automatically forward the calls over
the WAN if the destination directory number is not registered locally.
Answer: D
Cisco 642-457問題集 642-457問題集 642-457 642-457
NO.4 Which statement about Service Advertisement Framework is true?
A.SAF requires that the EIGRP be configured on all routers, including non-SAF routers.
B.SAF requires that the EIGRP be configured only on SAF routers. Non-SAF routers act as an IP cloud.
C.SAF has no dependency on the underlying routing protocol, as long as it is a dynamic routing protocol.
Static routes are not supported.
D.SAF operates on any dynamic or static IP routing configuration. SAF is totally independent of the
underlying routing protocol.
Answer: D
Cisco認証試験 642-457過去問 642-457過去問 642-457認定試験 642-457
NO.5 When an incoming PSTN call arrives at an MGCP gateway, how does the called number get normalized
to an internal directory number in Cisco Unified Communications Manager?
A.Normalization is done by configuring the significant digits for inbound calls on the MGCP gateway.
B.Normalization is done using route patterns.
C.Normalization is done using the gateway incoming called party prefixes based on number type.
D.Normalization is done using the gateway incoming calling party prefixes based on number type.
E.Normalization is achieved by local route group that is assigned to the MGCP gateway.
Answer: A
Cisco認定試験 642-457認証試験 642-457認定証 642-457参考書 642-457 642-457
NO.6 Refer to the exhibit.
The exhibit shows centralized Cisco Unified Communications Manager configuration components for
TEHO calls to U.S. area code 408 from the U.K. The PSTN access code for the U.K. is 9 and 001 for
international calls to the U.S. What should the TEHO-US route list configuration consist of?
A.First route group should point only to the U.K. gateway. The second route group should point to the U.S.
gateway.
B.First route group should be only the local route group. The second route group should point to the U.S.
gateway.
C.First route group should point only to the U.S. gateway. The second route group should be the local
route group.
D.The TEHO-US route list should contain only the local route group. The globalized configuration means
that the appropriate gateway will be selected automatically.
E.The \+! route pattern should point directly to the U.S. gateway.
Answer: C
Cisco 642-457認定試験 642-457 642-457認定資格
NO.7 Refer to the exhibit.
The exhibit shows centralized Cisco Unified Communications Manager configuration components for
TEHO calls to U.S. area code 408 from the U.K. The PSTN access code for the U.K. is 9 and 001 for
international calls to the U.S. To match the US-TEHO pattern \+!, how should the translation pattern be
configured?
A.9001.4085551234 with the Called Party Transformation:
Discard Digits PreDot
Prefix Digits Outgoing Calls: +
B.9.0014085551234 with the Called Party Transformation:
Discard Digits PreDot
Prefix Digits Outgoing Calls: +1
C.900.14085551234 with the Called Party Transformation:
Discard Digits PreDot
Prefix Digits Outgoing Calls: +1
D.900.14085551234 with the Called Party Transformation:
Discard Digits PreDot
Prefix Digits Outgoing Calls: +
E.001.4085551234 with the Called Party Transformation:
Prefix Digits Outgoing Calls: +
Answer: D
Cisco 642-457問題集 642-457認定試験
NO.8 When an incoming PSTN call arrives at an MGCP gateway, how does the calling number get
normalized to a global E.164 number with the + prefix in Cisco Unified Communications Manager?
A.Normalization is done using translation patterns.
B.Normalization is done using route patterns.
C.Normalization is done using the gateway incoming called party prefixes based on number type.
D.Normalization is done using the gateway incoming calling party prefixes based on number type.
E.Normalization is achieved by local route group that is assigned to the MGCP gateway.
Answer: D
Cisco認定証 642-457参考書 642-457認定資格
NO.9 Which two features require or may require configuring a SIP trunk? (Choose two.)
A.SIP gateway
B.Call Control Discovery between a Cisco Unified Communications Manager and Cisco Unified
Communications Manager Express
C.Cisco Device Mobility
D.Cisco Unified Mobility
E.registering a SIP phone
Answer: AB
Cisco 642-457 642-457 642-457問題集 642-457認証試験 642-457認定試験
NO.10 Refer to the exhibit.
The exhibit shows centralized Cisco Unified Communications Manager configuration components for
TEHO calls to U.S. area code 408 from the U.K. The PSTN access code for the U.K. is 9 and 001 for
international calls to the U.S. Assuming the PSTN does not accept globalized numbers with + prefix. What
should the Called Party Transformation Pattern at the U.S. gateway be configured as?
A.\+.! with the following Called Party Transformation:
Discard Digits PreDot
Prefix Digits Outgoing Calls: +
B.\+1.! with the following Called Party Transformation:
Discard Digits PreDot
Prefix Digits Outgoing Calls: None
C.\+408.! with the following Called Party Transformation:
Discard Digits PreDot
Prefix Digits Outgoing Calls: 1
D.\+1408.! with the following Called Party Transformation:
Discard Digits PreDot
Prefix Digits Outgoing Calls: None
E.\+1.408! with the following Called Party Transformation:
Discard Digits PreDot
Prefix Digits Outgoing Calls: None
Answer: D
Cisco 642-457 642-457認証試験 642-457認定証
NO.11 Refer to the exhibit.
What should the destination IP address be configured as on the HQ and BR1 SIP trunks?
A.The HQ SIP trunk destination IP address should be 10.1.6.10. The BR1 SIP trunk destination IP
address should be 10.1.5.10.
B.The destination IP address is not configurable. Each cluster will learn about the remote trunk IP address
through SAF learned routes.
C.The destination IP address will be learned automatically and configured on the SIP trunks after the
Cisco Unified Communications Managers discover themselves.
D.The HQ SIP trunk destination IP address should be the HQ SAF Forwarder IP address. The BR1 SIP
trunk destination IP address should be the BR1 SAF Forwarder IP address.
Answer: B
Cisco 642-457認定証 642-457認定証
NO.12 A Cisco 3825 needs to be added in Cisco Unified Communications Manager as an H.323 gateway.
What should the gateway type be?
A.H.323 gateway
B.Cisco 3825
C.Cisco 3800 series router. The specific model will be selected after the Cisco 3800 is selected.
D.The gateway can be added either as an H.323 gateway or Cisco 3800 series router.
E.The gateway can be added either as an H.323 gateway or Cisco 3825 series router.
Answer: A
Cisco 642-457認定試験 642-457 642-457認定試験 642-457認定試験
NO.13 Which process can localize a global E.164 with + prefix calling numbers for inbound calls to an IP phone
so that users see the calling number in a local format?
A.Calling number localization is done using translation patterns.
B.Calling number localization is done using route patterns.
C.Calling number localization is done by configuring a calling party transformation CSS at the phone.
D.Calling number localization is done by configuring a calling party transformation CSS at the gateway.
E.Calling number localization is done by configuring the phone directory number in a localized format.
Answer: C
Cisco 642-457 642-457 642-457 642-457参考書 642-457
NO.14 Assume that the Cisco IOS SAF Forwarder is configured correctly. Which minimum configurations on
Cisco Unified Communications Manager are needed for the SAF registration to take place?
A.SAF Trunk, SAF Security Profile, SAF Forwarder, and CCD Advertising Service
B.SAF Trunk, SAF Security Profile, SAF Forwarder, and CCD Requesting Service
C.SAF Trunk, SAF Security Profile, SAF Forwarder, CCD Requesting Service, and CCD Advertising
Service
D.SAF Trunk, SAF Security Profile, and SAF Forwarder
E.SAF Trunk, CCD Requesting Service, and CCD Advertising Service
Answer: B
Cisco認定証 642-457認定証 642-457 642-457
NO.15 Which method can be used to address variable-length dial plans?
A.Overlap sending and receiving.
B.Add a prefix for all calls that are longer than 10-digits long
C.Use nested translation patterns to eliminate inter-digit timeout
D.Use the @macro on the route pattern
E.Use MGCP gateways, which support variable-length dial plans
Answer: A
Cisco 642-457 642-457 642-457 642-457認定試験