Existing single-mode fiber optic cable network cabling installer is
corrupted. The crew was tugging at a new 12 armored fiber chain.
Operations Center within one of the men, without a ladder. Tugging at
his feet on the ground armored cable. Of which about 20 armored fiber
optic cable, and then continue through a hole in the ceiling.China Optical Distribution Frame
.
Henan Zhang Jixiang feather information mill Siheung eighties in the
last century. Are installing new cables and leaning against the large
fiber bundles. Mainly because he was grabbing his place on the floor, he
began by burning the jacket to the existing cable. All of the cables
may be set aside from a bundle in the center is no armor. Burned through
the existing non-armored cable,Cat6a Keystone Jack
and cat6a cabling are not much different than regular cat6 products you can see the new armored cable.
Elimination of a wing of the third floor of the network in New York
City hospital. I immediately contacted the emergency repairs. We have to
temporarily repair welding of fiber, that night. A few days later, we
have to do a permanent repair. When we begin to solve the problem, we
have no clue, have a damaged cable. We are just about the night before
installation of network cabling within the data center. We penetrate the
fiber panel connector end of the laser light within the fiber bundles.
When we look around, we have some lights on the ceiling. Once we saw a
large bundle of closer regional optical fiber through the wall, like a
Christmas tree lit up bright red. We want to isolate the breakthrough in
the wall. Somewhat lax and we withdraw from the wall, the whole room
lit up!
The moral of this story, please use the appropriate gear to add some
common sense! The simple laws of physics will tell you, you can not
pull down the cable to another cable or cable bundled with the
disaster's long-term friction. This is a very expensive repair, so that
the embarrassing scene of the contractor. Use your Noggin and you pull!