IT業種を選んだあなたは現状に自己満足することはきっとないですね。現在、どの業種の競争でも激しくなっていて、IT業種も例外ないですから、目標を立ったら勇気を持って目標を達成するために頑張るべきです。その中で、Ciscoの648-375日本語試験に受かることも競争力があるモードです。この試験に合格したら、あなたのITキャリアには明るい未来があるようになります。あなたを助けるために、我々のJPexamは真実かつ正確なトレーニング資料を提供します。JPexamを利用したら、あなたはきっと自分の理想を実現することができます。
人生にはあまりにも多くの変化および未知の誘惑がありますから、まだ若いときに自分自身のために強固な基盤を築くべきです。あなた準備しましたか。JPexamのCiscoの300-101試験トレーニング資料は最高のトレーニング資料です。IT職員としてのあなたは切迫感を感じましたか。JPexamを選んだら、成功への扉を開きます。頑張ってください。
JPexamがIT認証試験対策ツールのサイトで開発した問題集はとてもIT認証試験の受験生に適用します。JPexamが提供した研修ツールが対応性的なので君の貴重な時間とエネルギーを節約できます。
JPexamの問題集を購入したら、あなたの試験合格率が100%を保証いたします。もし試験に失敗したら、弊社が全額で返金いたします。
試験番号：648-375日本語問題集試験科目：Cisco Express Foundation for Systems Engineers (CXFS) Exam (648-375日本語版)
最近更新時間：2014-08-24
問題と解答：全102問 648-375日本語 認定資格
100％の返金保証。1年間の無料アップデート。
試験番号：300-101問題集試験科目：Implementing Cisco IP Routing (ROUTE v2.0)
最近更新時間：2014-08-24
問題と解答：全661問 300-101 受験記対策
100％の返金保証。1年間の無料アップデート。
試験番号：700-602問題集試験科目：UCS Invicta for System Engineers
最近更新時間：2014-08-24
問題と解答：全80問 700-602 学習資料
100％の返金保証。1年間の無料アップデート。
Ciscoの648-375日本語試験にもっと首尾よく合格したいのですか。そうしたら速くJPexamを選びましょう。JPexamは様々なIT認証試験を受ける人々に正確な試験資料を提供するサイトです。JPexamはIT職員としてのあなたに昇進するチャンスを与えられます。JPexam が提供したCiscoの648-375日本語試験に関する一部の無料の問題と解答を利用してみることができます。そうすると、我々の信頼性をテストできます。
購入前にお試し,私たちの試験の質問と回答のいずれかの無料サンプルをダウンロード：http://www.jpexam.com/300-101_exam.html
NO.1 The ABC Company BGP router is configured as shown below:
router bgp 64000 neighbor 172.16.1.1 remote-as 64000 neighbor 10.1.1.2 remote-as 64550
network 200.52.1.192 mask 255.255.255.224 no synchronization aggregate-address 200.52.1.0
255.255.255.0
The BGP peers 172.16.1.1 and 10.1.1.2 in the above configuration are established and working, as
well as the interface with IP address 200.52.1.192. Based on this information, which statement
below is true about your configuration?
A. Router TestK has an IBGP connection with neighbor 10.1.1.2.
B. Router TestK has an EBGP connection with the neighbor 172.16.1.1.
C. Router TestK advertises only a route 200.52.1.0 255.255.255.0 in BGP .
D. Router TestK advertises only a route 200.52.1.192 255.255.255.224 in BGP .
E. Router TestK advertises both the routes to 200.52.1.0 255.255.255.0 and 200.52.1.192
255.255.255.224 in BGP .
F. None of the other alternatives apply
Answer: E
Cisco試験 300-101短期 300-101問題集 300-101認定資格 300-101
NO.2 A network design shows that R1 has four different possible paths from itself to the Data
Center subnets. Which one of the following commands is most likely to show you all the possible
next-hop IP addresses for these four possible routes?
A. show ip eigrp topology
B. show ip eigrp topology all-links
C. show ip route eigrp
D. show ip route eigrp all-links
E. show ip eigrp topology all-learned
Answer: B
Ciscoふりーく 300-101問題 300-101書籍 300-101過去問 300-101
Explanation:
Of the five options, the show ip route eigrp all-links and show ip eigrp topology all-learned are not
valid commands. Both show ip eigrp topology and show ip route eigrp can show at most successor
and feasible successor routes. However, show ip eigrp topology all-links shows also nonfeasible
successor routes, making it more likely to show all possible neighbors.
NO.3 A ABC Company network administrator is troubleshooting an EIGRP configuration across a
discontiguous network. What must the administrator do to ensure all of the ABC Company routers
have the correct routing information?
A. The administrator must enable classless routing with the command "ip classless"
B. The administrator must disable automatic summarization with the command "no auto-summary"
C. The administrator must specify a default network with the command "ip default-network"
D. Nothing, EIGRP supports discontiguous networks by default.
E. The administrator must enable manual summarization with the command "ip summary-address"
F. None of the other alternatives apply
Answer: B
Cisco合格率 300-101認定証 300-101教育 300-101受験記 300-101
NO.4 R1 has 5 working interfaces, with EIGRP neighbors existing off each interface. R1 has routes for
subnets 10.1.1.0/ 24, 10.1.2.0/ 24, and 10.1.3.0/ 24, with EIGRP integer metrics of roughly 1 million, 2
million, and 3 million, respectively. An engineer then adds the ip summary-address eigrp 1
10.1.0.0 255.255.0.0 command to interface Fa0/ 0. Which of the following is true?
A. R1 loses and then reestablishes neighborships with all neighbors.
B. R1 no longer advertises 10.1.1.0/ 24 to neighbors connected to Fa0/ 0.
C. 1 advertises a 10.1.0.0/16 route out Fa0/ 0, with metric of around 3 million (largest metric of
component subnets).
D. R1 advertises a 10.1.0.0/16 route out Fa0/ 0, with metric of around 2 million (median metric of
component subnets).
Answer: B
Cisco独学 300-101費用 300-101関節
Explanation:
The ip summary-address command does reset neighborships, but only on the interface under which
it is configured. After those neighborships come up, R1 will advertise the summary route, but none
of the subordinate routes inside that summary. The summary route will us a metric equal to the
metric of the lowest metric subordinate route, approximately 1,000,000 in this casE.
NO.5 In computer networking a multicast address is an identifier for a group of hosts that have
joined a multicast group. Multicast addressing can be used in the Link Layer (OSI Layer 2), such as
Ethernet Multicast, as well as at the Internet Layer (OSI Layer 3) as IPv4 or IPv6 Multicast. Which
two descriptions are correct regarding multicast addressing?
A. The first 23 bits of the multicast MAC address are 0x01-00-5E. This is a reserved value that
indicates a multicast application.
B. The last 3 bytes (24 bits) of the multicast MAC address are 0x01-00-5E. This is a reserved value
that indicates a multicast application.
C. The first 3 bytes (24 bits) of the multicast MAC address are 0x01-00-5E. This is a reserved value
that indicates a multicast application.
D. To calculate the Layer 2 multicast address, the host maps the last 23 bits of the IP address into the
last 24 bits of the MAC address. The high-order bit is set to 0.
Answer: C,D
Ciscoふりーく 300-101認定証 300-101ふりーく
Explanation:
The point of this question is the form of multicast MAC address, and the conversion between the
multicast MAC address and IP address.
The multicast MAC address is 6 bytes(48 bits), the first 3 bytes (24 bits) of the multicast MAC
address are 0x01-00-5E, the last 3 bytes(24 bits) of the multicast MAC address =0 + 23 bit(the last 23
bit of the IP address). "0x01-00-5E" is a reserved value that indicates a multicast application. So
option B and D are correct.
NO.6 A link failure in the ABC Company network has caused the EIGRP routers to update their
routing tables. What action does PG1, an EIGRP router, take when it cannot find a feasible successor
for a network?
A. It examines the topology table for a next best path.
B. It transitions from passive to active state for that network and queries its neighbors.
C. It examines the routing and neighbor tables for the next best path.
D. It transitions from active to passive state for that network and queries its neighbors.
E. None of the other alternatives apply
Answer: B
Cisco費用 300-101 300-101問題集 300-101フリーク
NO.7 Router PG1 has a 256kbps serial interface link to another ABC Company location. The
configuration file of this interface is shown below:
interface serial 0/ 0
bandwidth 56
ip bandwidth-percent eigrp 1 200
From the command output above, how many kbps of bandwidth is allocated for EIGRP traffic?
A. 56 kbps
B. 112 kbps
C. 128 kbps
D. 256 kbps
E. None of the other alternatives apply
Answer: B
Cisco認定資格 300-101通信 300-101練習問題 300-101取得
NO.8 By default, which statement is correct regarding the redistribution of routes from other
routing protocols into OSPF?
A. They will appear in the OSPF routing table as type E1 routes.
B. They will appear in the OSPF routing table as type E2 routes.
C. Summarized routes are not accepted.
D. All imported routes will be automatically summarized when possible.
E. Only routes with lower administrative distances will be imported.
Answer: B
Cisco 300-101認定資格 300-101独学 300-101種類
Explanation:
Explanation Type E1 external routes calculate the cost by adding the external cost to the internal
cost of each link that the packet crosses while the external cost of E2 packet routes is always the
external cost only. E2 is useful if you do not want internal routing to determine the path. E1 is useful
when internal routing should be included in path selection. E2 is the default external metric when
redistributing routes from other routing protocols into OSPF.