Welcome to a Biomedical Battery specialist of the Nihon Kohden Battery
AMETEK Engineered Medical Components has received a U.S. patent for its design for an electrocardiogram (ECG) cable and electrical with battery like Nihon Kohden ECG-8110P Battery
, Nihon Kohden ECG-8420 Battery
, Nihon Kohden ECG-9020K Battery
, Nihon Kohden ECG-9130 Battery
, Nihon Kohden ECG-9320 Battery
, Nihon Kohden ECG-9620 Battery
, Nihon Kohden ECG-11A Battery
, Nihon Kohden FSB-2012K Battery
, Nihon Kohden LCS-2012NK Battery
, Nihon Kohden LCS-2912NK Battery
, Nihon Kohden MD-BY01 Battery
, Nihon Kohden QTC6210K Battery
, Nihon Kohden SB-901D Battery
, Nihon Kohden TEC-5500 Battery
assembly that exceeds the low-noise and electromagnetic interference standards established by the ANSI/AAMI EC-53 for ECG cable and lead wires.
The patented design includes a low-noise coating that is applied to the cable’s primary conductors and a shield that is applied over the conductors. The shield tightly binds the cable’s insulted conductors together, while a semi-conductive wall between the conductors and the shield reduces rubbing that can result in triboelectric charges. This proprietary cable construction can be applied to cables designed with three to 10 ECG position/patch configurations
Typically in an ECG cable, the signals received by the electrotrodes are very faint, occurring in the millivolt range. Noise in a signal may make an accurate diagnosis difficult, if not impossible. Minimizing the effect of electric noise on the signal is an extremely important element of ECG cable design.
Currently, ECG cables are required to meet ANSI/AAMI EC-53 standards, which established minimum requirements for range of critical electrical parameters, including cable and lead wire noise. And, while ANSI/AAMI EC-53 pertains specifically to ECG cables, the standard is commonly used to establish the performance requirements of other medical device cables.
Triboelectric noise can occur when a cable or shielded lead wire is flexed, causing internal conductors, or other components to rub together. These charges can occur in particular during emergency situations or stress testing when the cable is subject to movement. The EC-53 standard establishes test methods for measuring cable noise as well as a 50µV maximum for triboelectric noise.