Cryogenic Storage Vessel cleaning accidents in J

Therefore, in order to avoid a helium leak, usually try to avoid frequent Assembly and disassembly of the helium gas pipeline. In the helium compressor operation after years of seals should be replaced, in particular the solenoid valve gasket. Fault analysis and exclusion of Cryogenic Storage Vessel: check the main power switch is tripped if tripped, check that the input voltage is incorrect, check static pressure is within the limits prescribed by of the helium gas, if it is too low to add helium, helium gas pressure too high, deflated inflatable interface is required.


Fault analysis and elimination: Cryogenic Liquid Pump is installed on the main power switch and compressor switch. When starting the compressor you should turn on the main power switch, if the main power switch or compressor switch trips immediately, it means that the power supply voltage or phase sequence error error, need to access the correct power phase sequence and voltage. If the main power switch and compressor switch has not tripped, check for proper remote controller installation and use.

Therefore, the compressor cannot be started error is usually due to a power or remote controller is not installed properly. Of course, compressor circuit damage and PSA Oxygen Generator mechanical damage can also cause the compressor not running, is the most common fault due to a power supply phase sequence error, there will be a phase detector, a component is damaged.