Description: DW Vmax here Reserve address by: MAC Address; Click Continue. MAC Address: MAC hardware address of the DW Vmax IPv4 Address: DW Vmax here Click Done. Setup Port Mapping on the AEBSn. Dw-bjer4u, dw-bjer4u-lx Blackjack® E-RACK 4U 36-Bay Chassis DWC-MTT4Wi28, DWC-MTT4Wi36, DWC-MTT4Wi6.
First off, I am assuming that your AirPort Extreme Base Station is the ONLY router in your current network configuration. That is, is it connected directly to an Internet modem by Ethernet and that modem is in bridge mode (not providing NAT & DHCP services).
Microsoft visio full google drive windows 10.
To successfully access an IP camera on the local network from the Internet, the following basics need to be taken care of:
- Install the camera(s) and verify that you can access them from the local network.
- Configure port mapping/forwarding on your router. Typically, IP cameras require at least two ports: 1) A web port for administering the camera; Usually TCP port 80, and 2) A streaming port to broadcast the camera video feed; Usually UDP port 9000. Note: You should check with your camera's documentation for the exact ports required.
- If the camera is attached to a computer, you will need to configure the computer's firewall to open the same ports as in step 2 above.
- Test your network. Use CheckIP to determine your router's current WAN-side (public) IP address. Then, from a remote location (not from a computer on the local network), use the DynDNS Open Port Tool to verify that the required ports are open. Success is an 'Open' response from the Tool.
Dw Vmax Download For Mac
The following are general instructions on how to configure the AirPort for port mapping:
AEBSn - Port Mapping Setup
To setup port mapping on an 802.11n AirPort Extreme Base Station (AEBSn), either connect to the AEBSn's wireless network or temporarily connect directly, using an Ethernet cable, to one of the LAN port of the AEBSn, and then use the AirPort Utility, in Manual Setup, to make these settings:
1. Reserve a DHCP-provided IP address for the IP Camera.
AirPort Utility > Select the AEBSn > Manual Setup > Internet > DHCP tab
- On the DHCP tab, click the '+' (Add) button to enter DHCP Reservations.
- Description: <enter the desired description of the DW Vmax here>
- Reserve address by: MAC Address
- Click Continue.
- MAC Address: <enter the MAC hardware address of the DW Vmax>
- IPv4 Address: <enter the desired IP address that you want to reserve for the DW Vmax here>
- Click Done.
2. Setup Port Mapping on the AEBSn.
Dw Vmax For Mac
AirPort Utility > Select the AEBSn > Manual Setup >Advanced > Port Mapping tab
Dw Vmax For Mac
- Click the '+' (Add) button
- Service: <you can ignore this setting>
- Public UDP Port(s): 9010, 9011
- Public TCP Port(s): 80
- Private IP Address: <enter the reserved IP address of the DW Vmax here>
- Private UDP Port(s): 9010, 9011
- Private TCP Port(s): 80
- Click 'Continue'
Feb 3, 2013 2:19 PM