What is a quote vs invoice?
What is a quote vs invoice?
A price quote is given before any work is started. It details how much a project or job will cost. An invoice is provided after the work is complete. It lists the final costs and when payment is due.
What is O & O cost of an equipment?
Owning costs = purchase price of machine + financing + taxes – disposal price (what you get for that machine when you resell it). Operating costs = labor + fuel + maintenance + replacement costs of tires, tracks and other components + overhead. Add the owning to the operating costs and you have your O&O costs.
How much does it cost to bore and hone a block?
The usual cost for the honing or boring of the mains is $180. Once the mains are align-bored or honed, the centerline of the crankshaft is established. Next, the block is decked.
Can you rebuild engine without machining?
Without any machining, I'd call it an "overhaul" rather than a "rebuild". Overhauls were more common 50 years ago ... today most shops are unwilling to fix up a tired engine to get another 40,000 or 50,000 miles out of it. Usually an overhaul would include new rings, new rod bearings, and a valve grind.
Is it OK to hose off your engine?
Step 4: How to Wash a Car EngineOnce time is up for the degreaser, you have to hose it off. It is best not to use a high-pressure nozzle, as it may damage electrical connections even if you covered them. A regular garden hose with an adjustable nozzle set at “stream” will work well.
Can you spray your engine with water to clean it?
It's good you're taking care of your car! Spraying small amounts of water on your engine bay is okay. In fact, you should use hot water to help clean rust and dirt from collecting on your engine block. Just make sure you're not spraying water on it while your engine's hot, as this could cause it to crack.
Do heads need to be resurfaced?
Cylinder heads and blocks may need to be resurfaced to restore flatness or to improve the surface finish, or milled to change the deck height for a variety of reasons. The deck surface on the head or block may need to be resurfaced if the surface isn't smooth or flat.
How many times can a cylinder head be resurfaced?
The heads can be resurfaced repeatedly until the wear indicators I've circled below are met. Once the surface of the head reaches this point Subaru suggests replacement. You can resurface once or 50 times, doesn't matter.
What does the M in M-code mean?
M code is the machine control language that controls the overall program, often called G code. While G commands describe positions, M code directs the machine's actions. While M represents miscellaneous codes, some refer to it as machine code because it controls particular operations of the equipment.
How deep can a CNC router cut wood?
One of the main advantages of cutting and engraving with a CNC router is that you can make deep cuts of much more than one inch 1″ inch or 25mm of wood without mistreating or burning the material, and it does not matter if the wood is hard or soft, same can be processed.
What does the M in M-code stand for?
What does the M in M-code stand for?M-code (for “miscellaneous function”) is an auxiliary command; descriptions vary. Ma...