As you already know, your new lettering and graphic was produced by a computer and cut by a plotter specifically designed for this type of work. Do this slowly and take your time. Sitting beside you is the new vinyl lettering you had made for your vehicle. Youre ready to put it on exceptyou forgot what the custom shop told you do. Rub down the image <a href="http://www.baichaosheetmetal.com/">aluminum welding</a> on last time by covering it with an extra carrier sheets that may have come with your graphics. When you have applied the entire image to your vehicle, rub the entire thing again and apply more pressure to make sure you get out any bubbles and that its on there well.
Once youre ready to start, make sure you are in a comfortable position preferably sitting on a stool next to your vehicle so that you can hold your graphics and lettering steady.Youve just washed and waxed your car and its sparkling in the sunlight looking as sweet as they day you bought it. Pull the tape tightly and watch as the vinyl adheres to your vehicle. Place the entire sheet against the car, but do not peel off the backing. Once you remove the carrier sheet that holds your letter and graphics youre not going to be able to move them, so have the location planned out and ready before you even touch what youre applying. Have no fear, well walk you through it. Then carefully peel away the application tape by starting at a corner and pulling it free at an angle. They also apply to any pre-packaged ones you purchase at your local store. When you have half of the vinyl clear of the backing, hold the design above where you are going to apply it. Make sure you have plenty of time to devote to this project and when youre done, your vehicle will have a nice, new look. Rub the image onto the vehicle with a smooth flat edge, starting in the center and working your out. If you find any small remnants of vinyl around the edges of your lettering, carefully trim them away with a pair of scissors or very sharp utility knife.
.
These instructions do not only apply to customized graphics and lettering that you special ordered. Dont miss any area of the graphic. Make sure the area that you are going to apply this to is completely dry and free from any dirt or residue that will keep it from adhering. Dont pull it so tightly that you dislodge your masking tape. Do all your measuring to make sure its centered top to bottom, left to right, and then anchor the whole thing with some masking tape using a piece at the top and a piece at the bottom.
Now youre ready to remove the carrier sheet. It is best to take your time and do the job correctly because you will not be able to peel the vinyl off and start over.
Once you have that half applied, start with the next half and follow the directions from start to finish. When you do this, lift the vinyl image by the sticky application tape that will hold the vinyl image to your car and work in small section to trim away the backing as you go