I'm the lucky owner of an ASUS P5KC board, and I'm in the same boat as most other people here. Here's my current status: Downloaded and installed the AttansicL1Ethernet.kext using KextHelper. En1 up and running with no Mac address. (00:00:00 etc) When I use DHCP, it grabs a default 'out of network' IP. When IP and DNS is set manually, still no network, and no ping. Tried to use a guide to set MAC Address manually during startup, but the network tools all still show 00:00:00.
Asus P5B-E Plus BIOS 0108 2006-10-04 It is highly recommended to always use the most recent driver version available. Try to set a system restore point before installing a device driver. Asus P5b Ethernet Port Refusing To Detect - posted in Internal Hardware: Greetings to all forumites! First post here, so Ill try and make things as clear as I can.
Asus P5b Deluxe Motherboard Drivers
However, in Terminal, when I do ifconfig en1, It shows that it has a Mac Address (The mac address used in the instructions found on these forums). I think that I may have written down the MacAddress incorrectly, but as far as I know, that shouldn't make a difference, as long as there's no other identical Mac Addresses on my network, or am I wrong in assuming this? Any tips on how to go on from here? I've used 'ONE and ONLY' AttansicL1.kext from () for SL 10.6 & 10.6.2 on ASUS P5B-E (both i386 + x86_64 modes work great and better then original drivers in WinXP ). But sometimes i've got kernel panic with it ('.timeout.' Found solution: increase ' PCI Clocks' in BIOS (from 64 to 128 in my case). I was so happy when I found this thread!!!