On Monday the notebook motherboard splash, burned, but fortunately the accident insurance, didn't get it repaired. Last week three, busy on the phone, the Ipad fell to the treadmill, broke the screen. Then pick up the ipad 2 lcd, have a look, the heart is cold. The last Ipad is saying in the two generation to be listed before the lost, the two generation of broken, don't say three generation recently will be on the market? It also cannot use this tragic way -- Dutch act to preview, so sad.
Apple things are more precious, the store said repaired to 1100 yuan. To fix? Should I wait for three generation out for a? Then check the Internet, online sell the screen, said to be outside bad just a glass screen, a real screen inside, should be all right. The heart is secure some. By the name of the meeting went to Anshan West Road, inquire around a bit, from more than 500 to more than 800 have. Finally found a $550 in EGO, I feel fairly reliable, repair it.
This is the worst screen, from the volume keys at knock, shell deformation, the entire screen is broken. Machine repair Master said, Ipad screen is hard, positive how touch will not go bad, but afraid to knock the edge angle. The kind of protective sleeve so it is best to buy all inclusive, smartcover is useless. I use is smartcover, from the.
The first step in using the machine repair, hot hair dryer blowing repeatedly black screen edge, to soften the inside of the sealing rubber strip. This process will take about 5 minutes.
The rubber strip after softening, slot screen and body inserted with a blade, a little cock. This action should be slow, to prevent damage to the screen again the following screen damage.
If the rubber with relatively tight, again with hot wind blowing. This process is very long, about 20 minutes.
Well, the screen is unloaded. Look, here is the real glass screen display, be very careful not to touch is broken. With a tiger skin to broken glass and rubber debris blown clean.
Take the connection line between the display screen and a main board, put aside.
The glass screen is a capacitive screen, and the motherboard between also have connecting line, at the same time the Home key and before the cameras in this screen, is careful to put a few sample taken down. This step will be residual adhesive strips are removed down.
On the right is my Ipad2 screen body, left this is the new screen. According to the master is the same. Did not think even the things that are supporting the production of domestic.
This step is to remove the Home key, are ready to the new screen.
Internal ipad2, three pieces of black box is the battery side by side. ipad 2 digitizer replacementThe bottom below the battery board, a very small piece of. Look very simple. No wonder the processing fee to our account for only a small part.
Connect the new glass screen and the motherboard, the Home key and the camera are then connected.
The screen and the motherboard connected.
3M sealing strip according to the edge shape of cut, paste. Note do not cover screw holes (only 4) and keys.
The dust on the screen carefully wiped clean, otherwise you will always look at it.
A good screw, tear protection layer of 3M sealant.
The glass screen Ann back, pay attention not to the rivalry and frame deformation, or have to spend money.
Carefully on the corner by a solid, well. Maintenance work is done.
Spent 50 yuan on this film with the maintenance, spent a total of 600 yuan, than to buy a set of protection all surrounded by more expensive. Compared to the ultra-thin fashion sense, or safety is the most important.