いらっしゃいませ る~む335 です
いよいよ車体HULLが組みあがりました。
▲車体後部エアクリーナーやエンジン点検ハッチを取り付けました。
今回はいつも以上に丁寧な作業で進めています。
▲そしてHULL車体の組上がりです。
ガッチリ組むためにマステにてテンションかけています。
▲鋳造車体特有の丸みのあるフロントから角張った溶接車体へと流れていく様は
正にアメリカ!的です
▲車体後部は隙間が空き易いのでマステでグルグル巻きです
▲排気ディフレクター 焼鈍しをしたので少し変色していますが塗装するので大丈夫です
▲裏側から見た排気ディフレクター。
次回は車体組み上げ迄進めたいと思います。
デワデワ!!
**********************************************
Welcome to Ru-mu 335
The car body HULL is finally assembled.
▲ I installed an air cleaner at the rear of the car body and an engine inspection hatch.
This time, we are working more carefully than usual.
▲ And the assembly of the HULL body.
Tension is applied with a mast to assemble firmly.
▲ The flow from the rounded front peculiar to the cast car body to the angular welded car body
Just America! Is the target
▲ The rear part of the car body is easy to open, so it is wrapped around with a mast.
▲ Exhaust deflector Annealed so it is a little discolored, but it is okay to paint it.
▲ The exhaust deflector seen from the back side.
Next time, I would like to proceed to the assembly of the car body.
Dewa Dewa !!
***************************************************